Eaton E Series User Manual

2.1.6
Change Settings in the Protective Device
• Step 1: Change the setting values:•
A protection module that is required can be con󰊟gured only after it has been
activated. To do this, access the module in the [Device Planning] menu branch of
the tree structure and change the value of the »Mode« parameter from “-” (= “Do
not use”) to “Use”.
23www.eaton.comE-Series Family Quick Start Guide
2 Quick Start – Operating Software PowerPort-E
2.1.6 Change Settings in the Protective Device

Eaton E Series Specifications

General

Series	E Series
Operate Time	15 ms
Contact Arrangement	DPDT
Electrical Life	100, 000 operations
Vibration Resistance	10-55 Hz, 1.5 mm
Mechanical Life	10, 000, 000 operations