• “Local”: Control only via the buttons at the•
panel (HMI).
• “Remote”: Control only via SCADA, digital•
inputs or internal signals.
• “Local and Remote”: Control via HMI•
buttons, SCADA, digital inputs, or internal
signals.
Operational
Info
Ack/Rst
Ok
CTRL
The Softkey “Bkr” takes you to a screen with
settings for the connected switchgear device.
Exception for E-Series devices that support
more than one switchgear device: The Softkey
“Bkr” takes you to a screen that lists all
connected switchgear devices (not shown
here), and from this screen you can pick the
one that you are interested in.
(For the E-Series
relays »ETR-4000« and »ETR-5000«, up to
2 switchgear devices are supported.
The »EBR-3000« can control up to 2 Lockout
Relays. All other E-Series relays can control one
switchgear device.)
After selecting a switchgear device, the Softkey
“ ▶” (Enter) takes you to the menu that is
dedicated to the selected switchgear device.
There you can make various settings, e.g.
control times, position indicators, external
ON/OFF commands, interlockings.
Operational
Info
Ack/Rst
Ok
CTRL
The Softkey “ ▶” (Enter) takes you to an
enhanced single line (after you have entered
the password for access level “Control-Lv1”).
The switchgear device is highlighted by small
markers (and in case of several implemented
switchgear devices, the Softkey “Select” is
visible, which allows you to select another one).
If the switching authority permits local
switching there are Softkeys “OPEN” and
“CLOSE” which allow for executing a switching
operation. (Note that usually, i. e. with correct
position status indication from the switchgear
device, only one of these two Softkeys is
visible: If, for instance, a particular switchgear
device is already open, only the “CLOSE” is
visible.)
47www.eaton.comE-Series Family Quick Start Guide
3 Quick Start – Operation via Panel
3.9 “CTRL” key – Control Switchgear Devices
To Next Page
Loading...
