EDR-5000 IM02602007E
Name Description
Logic.LE80.Reset Latch-I State of the module input: Reset Signal for the Latching
Sgen.Running Signal: Measuring value simulation is running
Sgen.Ex Start Simulation-I State of the module input:External Start of Fault Simulation (Using the test parameters)
Sgen.ExBlo Module Input State: External Blocking
Sgen.Ex ForcePost-I State of the module input:Force Post state. Abort simulation.
Sys.PS 1 Signal: Parameter Set 1
Sys.PS 2 Signal: Parameter Set 2
Sys.PS 3 Signal: Parameter Set 3
Sys.PS 4 Signal: Parameter Set 4
Sys.PSS manual Signal: Manual switch over of a Parameter Set
Sys.PSS via Comm Signal: Parameter Set Switch via Communication
Sys.PSS via Inp fct Signal: Parameter Set Switch via Input Function
Sys.Min. 1 param changed Signal: At least one parameter has been changed
Sys.Program Mode Bypass Signal: Short-period bypass of the Program Mode.
Sys.Maint Mode Active Signal: Arc Flash Reduction Maintenance Active
Sys.Maint Mode Inactive Signal: Arc Flash Reduction Maintenance Inactive
Sys.MaintMode Manually Signal: Arc Flash Reduction Maintenance Manual Mode
Sys.Maint Mode Comm Signal: Arc Flash Reduction Maintenance Comm Mode
Sys.Maint Mode DI Signal: Arc Flash Reduction Maintenance Digital Input Mode
Sys.Ack LED Signal: LEDs Acknowledgment
Sys.Ack RO Signal: Acknowledgment of the Relay Outputs
Sys.Ack Comm Signal: Acknowledge Communication
Sys.Ack TripCmd Signal: Reset Trip Command
Sys.Ack LED-HMI Signal: LEDs Acknowledgment :HMI
Sys.Ack RO-HMI Signal: Acknowledgment of the Relay Outputs :HMI
Sys.Ack Comm-HMI Signal: Acknowledge Communication :HMI
Sys.Ack TripCmd-HMI Signal: Reset Trip Command :HMI
Sys.Ack LED-Comm Signal: LEDs Acknowledgment :Communication
Sys.Ack RO-Comm Signal: Acknowledgment of the Relay Outputs :Communication
Sys.Ack Counter-Comm Signal: Reset of all Counters :Communication
Sys.Ack Comm-Comm Signal: Acknowledge Communication :Communication
Sys.Ack TripCmd-Comm Signal: Reset Trip Command :Communication
Sys.Ack LED-I Module Input State: LEDs Acknowledgment by Digital Input.
Sys.Ack RO-I Module Input State: Acknowledgment of the Relay Outputs.
Sys.Ack Comm-I Module Input State: Acknowledge Communication via Digital Input. The replica that Communication has
received from the device is to be reset.
Sys.PS1-I State of the module input, respectively of the signal, that should activate this Parameter Setting Group.
www.eaton.com 1002
To Next Page
Loading...
