Eaton EDR-5000 - System Module Signals

EDR-5000 IM02602007E
System Module Signals
Signal Description
Reboot Signal: Rebooting the device: 1=Restart initiated by power supply; 2=Restart initiated by the User;
3=Set on defaults (Super Reset); 4=Restart by the debugger; 5=Restart because of configuration
change; 6=General failure; 7=Restart initiated by System Abort (host side); 8=Restart initiated by
watchdog timeout (host side); 9=Restart initiated by System Abort (dsp side); 10=Restart initiated
by watchdog timeout (dsp side); 11=Power supply failure (short term interruption) or power supply
voltage too low; 12=illegal memory access.
Act Set Signal: Active Parameter Set
PS 1 Signal: Parameter Set 1
PS 2 Signal: Parameter Set 2
PS 3 Signal: Parameter Set 3
PS 4 Signal: Parameter Set 4
PSS manual Signal: Manual switch over of a Parameter Set
PSS via Comm Signal: Parameter Set Switch via Communication
PSS via Inp fct Signal: Parameter Set Switch via Input Function
Min. 1 param changed Signal: At least one parameter has been changed
Program Mode Bypass Signal: Short-period bypass of the Program Mode.
Maint Mode Active Signal: Arc Flash Reduction Maintenance Active
Maint Mode Inactive Signal: Arc Flash Reduction Maintenance Inactive
MaintMode Manually Signal: Arc Flash Reduction Maintenance Manual Mode
Maint Mode Comm Signal: Arc Flash Reduction Maintenance Comm Mode
Maint Mode DI Signal: Arc Flash Reduction Maintenance Digital Input Mode
Param to be saved Number of parameters to be saved. 0 means that all parameter changes are overtaken.
Ack LED Signal: LEDs Acknowledgment
Ack RO Signal: Acknowledgment of the Relay Outputs
Ack Counter Signal: Reset of all Counters
Ack Comm Signal: Acknowledge Communication
Ack TripCmd Signal: Reset Trip Command
Ack LED-HMI Signal: LEDs Acknowledgment :HMI
Ack RO-HMI Signal: Acknowledgment of the Relay Outputs :HMI
Ack Counter-HMI Signal: Reset of all Counters :HMI
Ack Comm-HMI Signal: Acknowledge Communication :HMI
Ack TripCmd-HMI Signal: Reset Trip Command :HMI
Ack LED-Comm Signal: LEDs Acknowledgment :Communication
Ack RO-Comm Signal: Acknowledgment of the Relay Outputs :Communication
Ack Counter-Comm Signal: Reset of all Counters :Communication
Ack Comm-Comm Signal: Acknowledge Communication :Communication
Ack TripCmd-Comm Signal: Reset Trip Command :Communication
www.eaton.com 291