Eaton EDR-5000 - Page 638

EDR-5000 IM02602007E
Device Planning Parameters of the Sync-check Module
Parameter Description Options Default Menu path
Mode Mode Do not use,
Use
Use [Device Planning]
Global Protection Parameter of the Sync-check Module
Parameter Description Setting range Default Menu path
ExBlo1 External blocking of the module, if blocking is activated
(allowed) within a parameter set and if the state of the
assigned signal is true.
1..n, Assignment
List
-.- [Protection Para
/Global Prot Para
/Sync]
ExBlo2 External blocking of the module, if blocking is activated
(allowed) within a parameter set and if the state of the
assigned signal is true.
1..n, Assignment
List
-.- [Protection Para
/Global Prot Para
/Sync]
Bypass The Sync-check will be bypassed if the state of the
assigned signal (logic input) becomes true.
1..n, DI-LogicList -.- [Protection Para
/Global Prot Para
/Sync]
BkrCloseInitiate Breaker Close Initiate with synchronism check from any
control sources (e.g. HMI / SCADA). If the state of the
assigned signal becomes true, a Breaker Close will be
initiated (Trigger Source).
1..n,
SyncRequestList
-.- [Protection Para
/Global Prot Para
/Sync]
www.eaton.com 638