Eaton EDR-5000 - Page 842

EDR-5000 IM02602007E
Name Description
Logic.LE76.Timer Out Signal: Timer Output
Logic.LE76.Out Signal: Latched Output (Q)
Logic.LE76.Out inverted Signal: Negated Latched Output (Q NOT)
Logic.LE77.Gate Out Signal: Output of the logic gate
Logic.LE77.Timer Out Signal: Timer Output
Logic.LE77.Out Signal: Latched Output (Q)
Logic.LE77.Out inverted Signal: Negated Latched Output (Q NOT)
Logic.LE78.Gate Out Signal: Output of the logic gate
Logic.LE78.Timer Out Signal: Timer Output
Logic.LE78.Out Signal: Latched Output (Q)
Logic.LE78.Out inverted Signal: Negated Latched Output (Q NOT)
Logic.LE79.Gate Out Signal: Output of the logic gate
Logic.LE79.Timer Out Signal: Timer Output
Logic.LE79.Out Signal: Latched Output (Q)
Logic.LE79.Out inverted Signal: Negated Latched Output (Q NOT)
Logic.LE80.Gate Out Signal: Output of the logic gate
Logic.LE80.Timer Out Signal: Timer Output
Logic.LE80.Out Signal: Latched Output (Q)
Logic.LE80.Out inverted Signal: Negated Latched Output (Q NOT)
Sys.Maint Mode Active Signal: Arc Flash Reduction Maintenance Active
Sys.Maint Mode Comm Signal: Arc Flash Reduction Maintenance Comm Mode
Sys.Maint Mode DI Signal: Arc Flash Reduction Maintenance Digital Input Mode
Sys.Maint Mode Inactive Signal: Arc Flash Reduction Maintenance Inactive
Sys.MaintMode Manually Signal: Arc Flash Reduction Maintenance Manual Mode
Sys.Maint Mode-I Module Input State: Arc Flash Reduction Maintenance Switch
Sys.Min. 1 param changed Signal: At least one parameter has been changed
Sys.PS 1 Signal: Parameter Set 1
Sys.PS 2 Signal: Parameter Set 2
Sys.PS 3 Signal: Parameter Set 3
Sys.PS 4 Signal: Parameter Set 4
Sys.PS1-I State of the module input, respectively of the signal, that should activate this Parameter Setting Group.
Sys.PS2-I State of the module input, respectively of the signal, that should activate this Parameter Setting Group.
Sys.PS3-I State of the module input, respectively of the signal, that should activate this Parameter Setting Group.
Sys.PS4-I State of the module input, respectively of the signal, that should activate this Parameter Setting Group.
Sys.PSS manual Signal: Manual switch over of a Parameter Set
Sys.PSS via Comm Signal: Parameter Set Switch via Communication
Sys.PSS via Inp fct Signal: Parameter Set Switch via Input Function
www.eaton.com 842