Eaton EMR-4000 - Page 470

EMR-4000 IM02602009E
Setting Group Parameters of the Thermal Model
Parameter Description Setting range Default Menu path
Function Permanent activation or deactivation of module/element. Inactive,
Active
Active [Protection Para
/<1..4>
/49]
ExBlo Fc Activate (allow) or inactivate (disallow) blocking of the
module/element. This parameter is only effective if a
signal is assigned to the corresponding global protection
parameter. If the signal becomes true, those
modules/elements are blocked that are parameterized
"ExBlo Fc=active".
Inactive,
Active
Inactive [Protection Para
/<1..4>
/49]
Blo TripCmd Permanent blocking of the Trip Command of the
module/element.
Inactive,
Active
Inactive [Protection Para
/<1..4>
/49]
ExBlo TripCmd Fc Activate (allow) or inactivate (disallow) blocking of the
module/element. This parameter is only effective if a
signal is assigned to the corresponding global protection
parameter. If the signal becomes true, those
modules/elements are blocked that are parameterized
"ExBlo TripCmd Fc=active".
Inactive,
Active
Inactive [Protection Para
/<1..4>
/49]
Trip Function Turn on or off the trip function Inactive,
Active
Active [Protection Para
/<1..4>
/49]
Trip Threshold Trip threshold at which the thermal model will trip, based
on percentage of thermal capacity used. This value
should typically always be set at 0.99
Only available if: Trip Function = Active
0.60 - 0.99 0.99 [Protection Para
/<1..4>
/49]
Trip Delay Thermal capacity used trip delay
Only available if: Trip Function = Active
0.0 - 3600.0s 0.0s [Protection Para
/<1..4>
/49]
Alarm Function Turn on or off the alarm function Inactive,
Active
Active [Protection Para
/<1..4>
/49]
Alarm Threshold Alarm threshold at which the thermal model will trip,
based on percentage of thermal capacity used
Only available if: Alarm Function = Active
0.60 - 0.99 0.70 [Protection Para
/<1..4>
/49]
www.eaton.com 470