Eaton H-Max Series - Wiring; Schematic

Wiring
Schematic
A schematic is included with each product. The schematic number can be found on the product nameplate.
Typical schematics are shown on the next few pages.
NOTE:
Power and Motor Leads must be in separate conduit.
Do not run control wires in same conduit as input power or motor wires
Two grounding points are provided, input ground and output ground
Ground unit properly – improper grounding could damage the unit
26
Wiring
H-Max Series Drives IntelliPass®/IntelliDisconnect® IL04008003E April 2013 www.eaton.com