Setting and Unsetting
Page 22
Setting the system
1. Make sure the system is in standby.
2. Press the required button on the remote control. For example, Full Set
(A) or Part Set (B).
In a partitioned system, the default action is to full set or part set all of
the user's partitions.
3. You will hear a continuous exit tone (unless the system is configured
for silent or instant setting). The system sets as described in step 7 on
page 16.
If the system will not set
If one of the zones is active when you try to set the system, you will not
hear the exit warning tone. Instead, you will hear a single beep.
Try pressing A again on your remote control. If set up by the installer, the
system will omit the active detector and set. If the system does not set, you
will need to go to a keypad and investigate why the system will not set.
Unsetting the system
Note: An administrator can disable the ability for remote controls to unset
the system (see page 60).
1. Enter through the entry route designated by the installer.
2. Depending on how the system is configured, you may hear an entry
tone. If you hear the tone, you will have limited time to unset the
system before it generates an alarm.
3. Press on your remote control.
To Next Page
Loading...
Need help?
General
