User Menu Options
Page 63
Cloud This gives information about the connection to the
Eaton SecureConnect cloud, which your installer may
need for support purposes.
Expanders For each expander, this gives the expander's address,
its type and the version of software (firmware) installed.
Keypads For each keypad, this gives the keypad's address and
the version of software (firmware) installed.
Comms This gives information about the control unit's Ethernet
connection and any plug-on communications module
fitted. If required, please ask your installer for details
about the information displayed (as documented in the
Engineering Guide).
To use the About option:
1. Select About.
The following is displayed:
2. Press or followed by to select the option you require.
3. If applicable, press or followed by to select the sub-option.
4. If applicable, press or to display further information.
5. Press repeatedly to exit.
Generating a SecureConnect pairing code
You can use the Pair App option to generate a pairing code for the Eaton
SecureConnect app. The app allows you to monitor and control your alarm
system over the internet from your mobile phone or tablet.
The pairing code uniquely pairs your app with your panel and user code.
This ensures that any actions you carry out using the app will affect only
your panel, and are logged against your user code.
You are prompted to enter the code when you first open the app. The
pairing code lasts for 15 minutes.
For details of how to use the app, please refer to the SecureConnect App
User Guide.
To Next Page
Loading...
