Eaton i-on30R User Manual

User Menu Options
Page 47
Testing user HUAs
Master and admin users can use Test – User HUAs to test radio Hold-Up
Alarm (HUA) devices.
To carry out the test:
1. Select Test – User HUAs.
The following is displayed:


2. Press and hold both HUA buttons on the device you wish to test until
the transmit LED on the device flashes. If the device has a lock
button, make sure you unlock the button before the test.
The keypad gives a double-beep confirmation tone and you will see
the results of the test:


The top line shows the name of the user the device is allocated to.
The bottom line shows the strength of the signal. If the signal strength
is less than 4, contact your installer.
3. Repeat step 2 for the other HUA devices.
4. Press  to end the test.
Testing proximity tags
Master and admin users can use Test – Prox Tags to test proximity reader
tags.
To carry out the test:
1. Select Test – Prox Tags.
The following is displayed:


2. Hold the proximity tag against the front of the keypad.

Eaton i-on30R Specifications

General

Brand	Eaton
Model	i-on30R
Category	Security System
Language	English