Eaton i-on30R - Setting the Date and Time; Configuring Calendar Sets for Automation

User Menu Options
Page 46
bottom line shows the name of the output (which may be the same as
the address) and whether the output is currently on or off.
2. Press  or  to select the output.
3. Press  to switch the output on, and  again to switch it off. Check
that the output is working as expected. Outputs operated via radio
may take several seconds to change state.
4. Press  to end the test.
Testing remote controls
Master and admin users can use Test – Remotes to test remote controls.
To carry out the test:
1. Select Test – Remotes.
The following is displayed:


2. Press and hold a button on the device you wish to test until the
transmit LED on the device flashes.
The keypad gives a double-beep confirmation tone and you will see
the results of the test:


The top line shows the number of the device, the button you pressed,
and the name of the user the device is allocated to. The bottom line
shows the function of the button and the strength of the signal. If the
signal strength is less than 4, contact your installer.
3. Repeat step 2 for the other buttons. Note: If you wish to test the Hold-
Up Alarm buttons, make sure you press them both at the same time.
4. Press  to end the test.