User Menu Options
Page 37
Changing your access code or assigned devices
This section applies if you are a normal or partition user. If you are a
master or admin user, you will need to use Users – Edit User to carry out
these tasks (page 40).
To change your access code or assigned devices:
1. Select Users from the main menu.
2. Press or followed by to select one of the following options
(refer to "Adding users" on page 37 if you need information):
Code To change your own access code.
Prox Tag To add or delete your own proximity reader tag.
Remote To add or delete your own remote control. If you
are using a partitioned system and a two-way
remote control, you can also use a Remote
Partition option to specify the partition that the
remote control can set, unset, etc. Use or to
scroll through the partitions, and to choose
Yes or No. Press on completion.
You should delete your remote control if it has
been lost.
Hold Up Alarm To add or delete your own Hold-Up Alarm (HUA)
device.
3. Follow the prompts.
Adding users
If you are a master or admin user, you can use Users – Add User to add
new users. When adding a new user, you can:
Specify the user's name, type, partitions and access code.
Assign a proximity tag, remote control and radio Hold Up Alarm (HUA)
transmitter. If you do not wish to assign these devices, each user can
assign those devices to themselves at a later date using the Users
option.
Each user can have only one proximity tag, remote control or HUA
transmitter. No two users can have the same device.
A Duress user cannot have a remote control or HUA transmitter.
To Next Page
Loading...
Need help?
General
