User Menu Options
Page 39
Note: If you have a proximity tag that is already allocated, you can
find out who it belongs to by using Test – Prox Tag (page 42).
7. For user types that can set the system, you can assign a remote
control that is not already assigned to another user:
To assign a remote control, press any button on the remote control,
then (if you are using a partitioned system), choose one partition to
assign to the remote control.
If you do not want to assign a remote control, press at the above
prompt.
Note: If you have a remote control that is already allocated, you can
find out who it belongs to by using Test – Remotes (page 42).
8. For user types that can set the system, you can assign a radio HUA
(Hold-Up Alarm) device:
Press a button on an unallocated HUA transmitter until you see "HUA
added", or if you do not want to assign one.
Note: If you have an HUA transmitter that is already allocated, you
can find out who it belongs to by using Test – Hold Up Alarms (page
42).
Note: While you are registering a new HUA transmitter, the control
unit will not respond to an alarm signal from any radio HUA it has
already learnt.
9. If you are adding a Shunt Code user, press or followed by to
select the shunt group to assign to the user:
The * indicates the currently-selected shunt group.
10. The control unit confirms that the user has been added:
To Next Page
Loading...
Need help?
General
