Eaton i-on30R - Switching Outputs On;Off; Using the About Options

User Menu Options
Page 58
To re-program the buttons on a remote control:
1. Select System Config – Remotes – Edit.
The following is displayed:


2. EITHER:
a) Press the button on the remote control you want to re-program.
Hold down the button until you see the transmit LED flash.
OR (if you do not have the remote control):
a) Press  at the "Press Remote Button" prompt.
b) Use  or  followed by  to select the remote control you
want to re-program.
c) The display lists the first button on the remote control:


d) Use  or  followed by  to select the button you wish to re-
program.
The top line of the display shows the identity of the remote control, the
button you pressed or selected, and the name of the owner. For
example:


3. Use  or  followed by  to choose the function for the button:
Part Set (Two-way remote control only.) To set part set B/C/D (part-
setting system), or to part set the partition assigned to the
remote control (partitioned system). For a part-setting
system, use  or  followed by  to select the part set.
Output To operate a user-defined output. Use  or  followed by
 to select the output, then use  or  followed by  to
select the output mode:
 On – Switches the output on.
 Off – Switches the output off.