Eaton i-on40H - Using a One-Way Radio Keypad; Setting the System

Setting and Unsetting
Page 23
Using a one-way radio keypad
A one-way keypad (Figure 7) does not have a display and can only transmit
to the control unit (it cannot receive information back from the control unit).
Figure 7. One-way radio keypad
The keypad cannot show the status of the system. The left-hand “Transmit”
LED glows only to show that the keypad is sending a command to the
control unit.
Setting the system
1. Make sure the system is in standby.
2. Enter a valid access code or present your proximity tag to the keypad.
3. Press:
A – To set the system fully (part-setting system) or to set partition 1.
B – To set part set B (part-setting system) or to set partition 2.
C – To set part set C (part-setting system) or to set partition 3.
D – To set part set D (part-setting system) or to set partition 4.
4. You will hear a continuous exit tone (unless the system is configured
for silent or instant setting). The system sets as described in step 7 on
page 16.
A
B
C
D
1
4 ghi
7 pqrs
* 0 #
2 abc
5 jkl
3 def
6 mno
8 tuv 9 w xyz
“Transmit” LED
Proximity tag
sensor