User Menu Options
Page 44
Performing a walk test
Master and admin users can use Test – Walk Test to test detectors without
starting an alarm. Walking past motion detectors should be enough to
trigger them. If you have detectors connected to doors or windows, you will
have to open them to trigger those detectors.
During the test, if the detector is working, the control unit sounds a
confirmation tone and indicates that the detector has passed the test.
Note: You cannot test wired HUA buttons, fire detectors, and 24-hour
zones during a walk test. The control unit will always start an alarm if you
activate those detectors.
To carry out the test:
1. Select Test – Walk Test. The following is displayed:
2. Press or to select one of the following:
Once Causes keypads and loudspeakers to chime only once for
each zone that is triggered during the walk test.
On Generates a chime every time a zone is triggered.
Off Switches off chiming.
3. Press or followed by to select the method of testing:
System This option allows you to walk round the entire system and
test all the zones.
Partitions (Partitioned systems only.) This option allows you to select
one or more partitions, and test only the zones within those
partitions.
Press or to scroll up or down the list of partitions, and
to display “Yes” at the end of the bottom line to mark the
partition as one you want to test.
Zones This option lets you select one or more individual zones,
and test only those zones.
Press or to scroll up and down the list of zones. Press
to display “Yes” at the end of the bottom line to mark the
zone as one you want to test.
To Next Page
Loading...
