Eaton i-on40H - Managing Remote Controls

User Menu Options
Page 57
Managing remote controls
Master and admin users can use System Config – Remotes to specify the
functions that can be carried out using remote controls. The System Config
– Remotes menu contains the following options:
Edit Used to edit the programming of the buttons, such as
the buttons used to set or unset the system, or operate
outputs.
Delete Deletes a selected remote control.
Delete All Deletes all remote controls.
Unset Enables or disables the ability for all remote controls to
unset the system.
HUA Function Enables or disables the ability for remote controls to
generate Hold-Up Alarms (HUAs).
These options are described next.
Editing the programming of the buttons
You can use System Config – Remotes – Edit to re-program buttons on a
one-way remote control, or the “*” button on a two-way remote control, after
the devices have been assigned to a user.
A button can be programmed to:
 Set a selected part set (part-setting system only).
 Part set a partition (partitioned system only).
 Operate an output configured as "User Defined" by the installer.
 Full set the whole system (one-way remote control only).
 Unset the whole system (one-way remote control only).
 Full set a partition (partitioned system, one-way remote control only).
 Unset a partition (partitioned system, one-way remote control only).
Note for one-way remote controls:
 If you have a part-setting (non-partitioned) system, you cannot
reprogram the unset button.
 If you have a partitioned system, the unset button can only be used to
unset some or all partitions allocated to the user.