Eaton i-on40H - Testing Outputs

User Menu Options
Page 45
4. Press  to begin the test.
The top line shows how many detectors remain to be tested. The
bottom line provides a list of all the detectors ready for testing (press
 or  to scroll through the zones):


5. Walk round and trigger each detector in turn. If you have enabled
Chime, the keypads and loudspeakers give a double-tone chime when
you trigger a detector.
You can see which zones still need to be tested by pressing  or 
to scroll through the zones: an "A" is shown at the end of the bottom
line for each zone that has been tested. Alternatively, you can press
and scroll through the untested zones (press again to continue
with the test).
6. If you wish, you can press  to finish the test early.
7. Once all zones are tested, you will see (for example):


Testing outputs
Master and admin users can use Test – Outputs to test outputs the installer
has configured as "User Defined". The outputs may be used to control
external devices, such as lights or locking equipment.
Note: You can activate or deactivate user-defined outputs at any time (see
page 62).
To carry out the test:
1. Select Test – Outputs.
The display shows the first in a list of any user-defined outputs
allocated for your use. For example:


The top line shows the address and type of the output. In the above
example, the address is PAN>01 and the type is W (wired). The