Setting and Unsetting
Page 24
Unsetting the system
1. Enter through the entry route designated by the installer.
2. Depending on how the system is configured, you may hear an entry
tone. If you hear the tone, go directly to the keypad, since you will
have limited time to unset the system before it generates an alarm.
3. Enter your access code or present your proximity tag to the keypad.
4. Press .
Using SMS command messaging
Using a mobile phone or other messaging device, you can send SMS
messages to the control unit to set/unset the system, activate/deactivate
outputs, omit/un-omit zones or query the current status of the system.
Please refer to the "SMS Command Messaging User's Guide" for further
information.
To Next Page
Loading...
