Eaton i-on40H - Switching Outputs On;Off; Using the about Options

User Menu Options
Page 62
Press  if you decide you want to abandon the call.
3. When the installer has finished and the connection is broken, the
display shows the standard standby screen. For example:


Switching outputs on/off
Master and admin users can use Outputs On/Off to switch outputs on or off
as follows:
1. Select Outputs On/Off.
The display shows the first in a list of any outputs allocated for your
use. For example:


The top line shows the address and type of the output. In the above
example, the address is PAN>01 and the type is W (wired). The
bottom line shows the name of the output (which may be the same as
the address) and whether the output is currently on or off.
2. Press  or  to select the output.
3. Press  or  to switch the output on or off. Outputs operated via
radio may take several seconds to change state.
4. Press  repeatedly to exit.
Using the About options
If you are a master or admin user, you can use the About option to find
information about the system you are using. The About menu contains the
following options:
Panel This gives:
 The control unit model (e.g. i-on40H).
 The control unit's software (firmware) version
number.
 Whether the control unit is in partitioned or part-
setting mode.
 The installed languages and their versions.