User Menu Options
Page 61
Enabling or disabling HUA functions
You can use System Config – Remotes – HUA Function to enable or
disable the ability for a two-way remote control to generate Hold-Up Alarms
(HUAs).
Note: The installer must first enable this feature by configuring "Basic"
confirmation mode. Doing so means that the system does not comply with
BS8243 or DD243.
After selecting HUA Function, use or to select Enabled or Disabled,
followed by .
See page 21 for details of how to generate an HUA using a two-way
remote control.
Starting a call to Downloader
Master users can use System Config – Call Downloader to start a
connection to the installer's Downloader software via a telephone
connection or across an Ethernet network. The installer can use
Downloader to configure your alarm system.
Depending on how the installer has configured your system, you may be
asked to use System Config – Call Downloader to start the connection to
Downloader. Alternatively, the installer may be able to start the connection,
but this requires you to enable System Config – Facilities On/Off – Remote
Access (page 49).
To start the connection:
1. Select System Config – Call Downloader.
The following is displayed:
2. Press or to choose Tel No 01, Tel No 02, IP Address 1 or IP
Address 2 (as specified by your installer), then press . You do not
need to know the actual telephone numbers or P addresses.
The keypad displays the following, followed by a series of progress
messages:
Your system may be connected to Downloader for some time.
To Next Page
Loading...
