Eaton i-on40H - Page 64

User Menu Options
Page 60
Deleting remote controls
You may want to delete a remote control if is lost or you want to reassign it
to another user. You must delete a remote control before you can reassign
it to another user.
The System Config – Remotes menu provides two options for deleting
remote controls:
Delete This allows you to delete a specific remote control (see
below).
Delete All This deletes all remote controls that the system learnt.
You should use this option only if you are sure you want
to delete all remote controls.
To delete a specific remote control:
1. Select System Config – Remotes – Delete.
The following is displayed:


2. Press the button on the remote control you want to delete.
Alternatively, if you do not have the remote control, press , then use
 or  to choose the remote control, followed by .
The following is displayed:


3. Press  to delete the remote control.
Enabling or disabling unsetting
You can use System Config – Remotes – Unset to enable or disable the
ability for all remote controls to unset the system. By default, remote
controls are able to unset the system, but you may want to change this for
security reasons.
After selecting Unset, use  or  to select Enabled or Disabled, followed
by .
Disabling Unset does not affect the ability for remote controls to set the
system.