Eaton i-on40H - Page 63

User Menu Options
Page 59
 Toggle – Changes the state of the output each time
you press the button.
Set/Unset (One-way remote control only.) To set or unset the system.
Choose Set or Unset, then use  or  followed by  to
select the set/unsetting mode:
 Unset All – Unsets all partitions that the user belongs
to.
 Unset Partitions – Unsets selected partitions that the
user belongs to. After selecting this option, use  or
 to scroll through the partitions and use  or  to
choose whether the partition should be unset by the
button. Press  when you have finished.
 Part Set All (partitioned system) – Part sets all
partitions that the user belongs to.
 Partitions (partitioned system) – Full sets or part sets
selected partitions that the user belongs to. After
selecting this option, use  or  to scroll through the
partitions and use  or  to select No (do not set
partition), Full (full set the partition) or Part (part set
the partition). Press  when you have finished.
 Full Set All (partitioned system) – Full sets all
partitions that the user belongs to.
 Full Set (part-setting system) – Full sets the whole
system.
 Part Set B\C\D (part-setting system) – Sets part set B,
C or D.
Note: If you choose Unset, ask your installer whether the
entry timer needs to be running before a user can unset
using a remote control.
4. Press  repeatedly to exit.