User Menu Options
Page 49
communications, the second line or IP address may be used if the first
fails to connect.
4. Press to start the test.
The keypad shows the progress of the call. Check with the ARC that
the test call arrived. If the call fails, the display shows “Call failed”,
followed by the reason.
System configuration
The System Config menu allows you to change some parts of the system
to suit your particular needs.
Note: For normal and partition users, the System Config menu contains
only the Chime and Level 4 Update options (see below).
Switching facilities on/off
System Config – Facilities On/Off can be used to switch the following
facilities on or off:
Chime Use this option to enable or disable the chimes that
occur when a zone is triggered that has a Chime
attribute (as set up by the installer). For most zone
types, a chime occurs only when the system is unset.
Remote Access A master user can use this option to enable or disable
remote access to the control unit from the web interface
or Downloader software.
Note: By default, this feature is off for security reasons.
Make sure that any installer requesting access is your
authorised installer. Switch off remote access once the
installer has finished.
Note: If you turn remote access off, you can still make
the control unit start a call out to an installer who is
using the Downloader software (see page 61).
Level 4 Update Use this option to enable or disable access to the
control unit from the level-4 user. There can be only one
level-4 user, which only the installer can create.
To Next Page
Loading...
