EasyManua.ls Logo

Eaton Network Shutdown Module V3 - 7 Appendix; Single UPS Mode Compatibility; Card;Proxy Compatibility; Upss Compatibility

Eaton Network Shutdown Module V3
65 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.eaton.com
Network Shutdown Module V3 – User Manual - 34 003 934 XU / AE Page 34/65
7 Appendix
7.1 Single UPS Mode compatibility
7.1.1 Card/Proxy compatibility
In single UPS Mode, Network Shutdown Module V3 is compatible with following cards/Proxy:
z Network Management Card Minislot 66102 (BA is the Minimum firmware revision)
z Industrial Network Management Card Minislot 66103
z Network Management Card Transverse 66074
z Network Management Card Minislot – 66244
z Network Management Proxy V5
7.1.2 UPSs compatibility
In Single UPS Mode, the following UPSs are compatible through the Cards/Proxy:
z Pulsar, Pulsar M, EX
z Pulsar Extreme C
z Pulsar & Comet EXtreme
z Evolution & Pulsar Evolution
z Pulsar MX, MX
z Pulsar EX RT, Comet EX RT, EXRT
In Multi-UPS mode you also have to check the following Multi-ups mode compatibility list.
7.2 Multi-UPS Mode Compatibility list
7.2.1 Caution
We strongly recommend you contact trained EATON personnel for setup, in order to guarantee the integrity of
your high-availability system.
7.2.2 « simple » configurations
z UPSs in parallel:
Single Phase Pulsar MX 1+1 (2 Max)
MX 1+1 (2 Max)

Table of Contents