INSTALLATION
Eaton 5125 Rack-Mount UPS (5000/6000 VA) User's Guide S 164201541 Rev D
www.eaton.com/powerquality
23
4. Using two clip nuts and two hex-head screws, attach the rail to the
rear of the rack (see Figure 5 and Figure 6).
The bottom rail uses positions 2 and 4 for the rear hex-head
screws. If you are installing additional rails, the next rail should be
placed 7 holes above the last installed screw.
Position 2
Position 4
Position 11
Position 13
First Rail
Second Rail
Figure 5. Rear Rail Screw Positions
Clip Nuts
Figure 6. Securing the Rear Rail
To Next Page
Loading...
