Eaton Powerware 5125 - Additional UPS Features

Eaton 5125 Rack-Mount UPS (5000/6000 VA) User's Guide S 164201541 Rev D
www.eaton.com/powerquality
47
Chapter 6 Additional UPS Features
This section describes the:
S USB port
S DB-9 communication port
S X-Slot cards
S Load segments
The Eaton 5125 UPS includes a USB port, a DB-9 communication port,
and an X-Slot communication bay or card. Only one communication
option may be used to monitor the UPS; they cannot operate
simultaneously.
USB Port
The UPS can communicate with a USB-compliant computer using
LanSafe
®
Power Management Software (v5.0.1 or higher).
To establish communication between the UPS and a computer:
1. Connect the USB cable to the USB port on the UPS rear panel (see
Figure 22).
Connect the other end of the USB cable to the USB port on your
computer.
USB Port
Figure 22. The USB Port
2. Install the LanSafe software and USB drivers according to the
instructions provided with the Software Suite CD.