Eaton Powerware 9155 - Page 20

UPS ONLY INSTALLATION
EATON Powerware
®
9155 UPS (8–15 kVA) User’s Guide S 164201553 Rev F www.powerware.com
14
ON
OFF
UPS Wiring
Access Cover
Conduit Landing
Battery Circuit Breaker
Figure 6. UPS Rear View
6. Remove the UPS wiring access cover and retain (see Figure 6).
7. Install conduit and hardwire the input, output, and ground terminations for the
UPS.
See Table 1 for specifications and Figure 7 for a detailed view of the UPS
terminal block.
8. Replace the UPS wiring access cover.
9. Continue to “Stabilizing the Cabinet” on page 43 to complete the UPS
installation.