36
Chapter 6—Installation requirements
POWERXL SERIES VFD MN040002EN—February 2018 www.eaton.com
FR6 mounting instructions
Step 1: Remove the carton from the drive.
Step 2: Remove the four screws (used to fix the drive to the
pallet) with an M8 or 3/8 inch wrench.
Step 3: Use a hook to lift the drive.
Step 4: Attach the drive to the mounting plate with four
M8x20 or 3/8 inch screws and four M8 or 3/8 inch
nuts with an M8 or 3/8 inch wrench. The opening
dimensions on the mounting plate should follow
required dimensions (refer to the drive mounting
template printed on the outside carton).
Screw: Four M8x20
or 3/8 inch
Nut: Four M8
or 3/8 inch
ote: N The TLK series lug from KST for connecting is
recommended, but other types can be used. The
rated lug hole should be 1/2 inch or 13 mm to
supportthe FR6 stud.
To Next Page
Loading...
