Eaton PowerXL DH1 - Rubber Grommet Installation Instructions

42
Chapter 6—Installation requirements
POWERXL SERIES VFD MN040002EN—February 2018 www.eaton.com
Rubber grommet installation instructions
Step 1: Measure the outside diameter of the cable (D1)
used to connect to the drive.
D1 (Cable)
Step 2: Measure the outside diameter of the
rubbergrommet (D2) and select a suitable
D2 (D1 ≤ D2 ≤ D1 + 2 mm).
D2 (Grommet)
Step 3: Cut the rubber grommet at the selected diameter.
D1 ≤ D2 ≤ D1 + 2 mm
Step 4: Run the cable through the rubber grommet.
Step 5: Insert the rubber grommet into the conduit plate
together with the cable.
Step 6: Fasten the rubber grommet and cable with a
self-locking cable tie.
Self-Locking Cable Ties