10 Industrial Ethernet Communication Adapter Modules (ECAM)
10.3 Profinet
156 PXR Electronic trip unit 01/21 MN012005EN www.eaton.com
10.3.4.7 Primary status codes
Table 94: Primary status codes - Profinet
10.3.4.8 Secondary status codes
Table 95: Secondary status codes - Profinet
10.3.4.9 Reason codes
Table 96: Reason codes - Profinet
Code
Meaning
0x01 open
0x02 closed
0x03 tripped
0x04 Alarm active
0x0D Threshold value active
Code Meaning
0x01 not applicable
0x03 Test mode
0x07
has been switched on since last trip / triggered alarm
0x08 alarm
Code Meaning
0x0000 unknown
0x0001 normal
0x0003
Instantaneous short circuit
0x000E
Auxiliary power supply too low
0x0011
Current imbalance
0x0021
Control via the communication interface
0x0025
Coil monitoring
0x002B
Diagnostic warning #2 (configuration read error)
0x003D Overload
0x003E Short-time delay
0x0049 Phase currents are close to the threshold value, load alarm
0x004C Override
0x004D
Setpoint error
0x004E
Overtemperature
0x0050 Overload (neutral conductor)
0x0054 Ground fault
0x0071 Calibration
To Next Page
Loading...
