Ecco Axios - User Manual

Questions and Answers

S
Steven ChavezAug 4, 2025
What to do if Ecco Lighting Equipment does not function?
- R
  rodriguezdillonAug 4, 2025
  If your Ecco Lighting Equipment isn't working, start by checking the fuse, cables, and connections to both the lightbar and the controller. If you find a blown fuse, examine the wiring and replace the fuse. If the issue continues, try replacing the controller with a known working unit. It could be due to poor power or ground connection, or a blown fuse.
J
Joseph JamesAug 10, 2025
Why both/all lights of Ecco Axios Lighting Equipment do not function?
- R
  richardgibsonAug 10, 2025
  If all lights on your Ecco Lighting Equipment are not working, there could be several reasons: * A blown fuse: Check the wiring and replace the fuse if necessary. * No power: Ensure the vehicle's STI lights are functioning correctly, as the lightbar requires power. * Failed STI LED module: Make sure the STI module is properly plugged in and replace it if needed.
J
Jennifer MontesAug 16, 2025
What to do if one light of Ecco Axios Lighting Equipment does not function?
- C
  Christina HernandezAug 16, 2025
  If one light on your Ecco Lighting Equipment isn't working, plug a working module into the chassis. The issue might be a failed LED module or central control board.
M
mcoxAug 22, 2025
Why LED modules of Ecco Axios Lighting Equipment flashes dimly?
- A
  Austin BellAug 22, 2025
  If the LED modules on your Ecco Lighting Equipment are flashing dimly, it could be due to a defective module or central control board. If only one module is dim, replace that specific module. If all modules are dim, check that the lightbar voltage is greater than 11V.
D
David EdwardsAug 28, 2025
How to repair one or two LED modules of Ecco Axios Lighting Equipment that do not flash?
- A
  Amanda McneilAug 28, 2025
  If one or two LED modules on your Ecco Lighting Equipment aren't flashing, but the Pattern 1 or Pattern 2 indicator LED on the controller is on, it could be due to an open circuit in the wiring from the central control board to the LED module. Verify the correct installation of the modules in the power rail, if problem persists, replace the modules. Another cause may be failed LED module.