ECD 100-181 - Page 47

To Next Page

To Previous Page

L I Q U I D C R Y S T A L D I S P L A Y

Number of runs or front door/rear operations

The counting value is in decimal.

> FORWARDS

Floor Positioning

See Motion. Counting method 01.

02- NOR IDL ][][

Log Run/Door Ops

02- NOR IDL ][][

Flr Positioning

Main Page

Table of Contents3
Section 1: Safety Regulations & Introduction6
- Following Operating Instructions6
- Obligations of Operator6
- Obligations of Personnel6
- Hazards Associated with the Equipment7
- Warranty and Liability7
- 1.2.6 Organizational Measures7
- 1.2.7 Protective Equipment8
- 1.2.8 Informal Safety Measures8
- 1.2.9 Training of Personnel8
- 1.2.10 Machine Controls8
- 1.2.11 Safety Measures During Normal Operation8
- 1.2.12 Hazards Caused by Electric Power8
- 1.2.13 Hazards Caused by Hydraulic Power9
- Special Danger Areas (Examples)9
- 1.2.15 Controller Installation Environmental Requirements9
- Introduction10
Section 2: Eeprom Settings11
Eeprom Version 4.02 Summary12
Eeprom Definitions (Full Description)15
- ADO - Advanced Door Opening Setup15
- ALP - Auxiliary Leveling Pump Operation Setup15
- ANS - Anti Nuisance Setup15
- BCC - Bottom Car Call Setup15
- BOT - Bottom Floor Setup15
- BST - Brake Switch Time16
- CCMF - Car Call Mask (Front Doors) Setup16
- CCMR - Car Call Mask (Rear Doors) Setup16
- CNT - CNT Input Setup16
- COD - Parameter Lockout Function17
- DCMF - down Call Mask (Front Doors) Setup17
- DCMR - down Call Mask (Rear Doors) Setup17
- DLI - Door Limit Invert Setup17
- DLM - Door Limit Setup18
- DRV - Drive Type Setup18
- DT - Door Time Close Setup18
- DTCF - Door Time Car Call (Front Doors) Close Setup18
- DTCR - Door Time Car Call (Rear Doors) Close Setup18
- DTHF - Door Time Hall Call (Front Doors) Close Setup19
- DTHR - Door Time Hall Call (Rear Doors) Close Setup19
- DTL - Door Time Lobby Call Close Setup19
- DTRF - Door Time Recall Front Setup19
- DTRR - Door Time Recall Rear Setup19
- Eqk20
- FS - Fire Service Type20
- HFAF - Hall Fire Alternate (Front Doors) Floor Setup20
- HFAR - Hall Fire Alternate (Rear Doors) Floor Setup20
- HFSF - Hall Fire Service (Front Doors) Return Floor Setup20
- HFSR - Hall Fire Service (Rear Doors) Return Floor Setup21
- HRF - Hospital / Hall Recall Front Doors21
- HRR - Hospital / Hall Recall Rear Doors21
- LCK - Parameter Lockout Function21
- LOB - Lobby Floor Setup21
- L.# - Lift Number Setup21
- MOD - MODE Inputs Setup22
- MSL - Magnet Slowing Type22
- NR - Door Nudging Setup22
- PRK - Park/Zone with Doors Open22
- PRV - Proving Required Setup22
- RLV - Re-Leveling Setup22
- RPT - Run Protection Timer Setup23
- RTM - Run Time Short Floor Run Setup23
- SDX - Star Delta Exchange Time Setup23
- SDX - VF Drive Setting 06,07,08 Brake Drop Time23
- SFR - Short Floor Run Setup23
- Spares24
- Stf - Start Fast24
- Stm - Start Medium24
- Slf - Slow Fast24
- Slm - Slow Medium24
- ST2 - Star Delta Changeover Time Setup24
- ST2 - VF Drive Setting 06,07,08 End Run Time24
- TCC - Top Car Call Setup24
- TOP - Top Floor Setup25
- UCMF - up Call Mask (Front Doors) Setup25
- UCMR - up Call Mask (Rear Doors) Setup25
- XTM - Extend Run Time Short Floor Run25
- ZON - Zoning/Parking Floor Setup25
- ZTM - Zoning Time Setup26
- L - Number of Lifts Setup26
Section 3. Group27
- Group Connections and Communication27
- Group Checks28
- Group/Duplex Faults28
Section 4. Inputs - Outputs29
- BRK - Brake Relay Output29
- BSL - Bottom Slowing Input29
- CBSF - Hall Button Stop (Front Doors) Output29
- CBSR - Hall Button Stop (Rear Doors) Output29
- CC - Car Call Inputs/Darlington Outputs29
- CFS - Car Fire Service Input30
CFSS - Car Fire Service Start Input30
DCBF - Door Close Button (Front Doors) Input30
DCBR - Door Close Button (Rear Doors) Input30
DCF - Door Close (Front Doors) Relay Output30
DCR - Door Close (Rear Doors) Relay Output30
DDN - Direction down Output30
DDO - Door Open Disable Input / Toggle Switch30
DF - down Fast Relay Output31
DFCF - Door Fully Closed (Front Doors) Input31
DFCR - Door Fully Closed (Rear Doors) Input31
DFOF - Door Fully Open (Front Doors) Input33
DFOR - Door Fully Open (Rear Doors) Input33
DHC - down Hall Call Inputs/Darlington Outputs34
DN - down Relay Output35
DOBF - Door Open Button (Front Doors) Input35
DOBR - Door Open Button (Rear Doors) Input35
DOF - Door Open (Front Doors) Relay Output35
DOR - Door Open (Rear Doors) Relay Output35
DS - down Slow Relay Output35
DUP - Direction up Output35
DZ - Door Zone Input35
DZ - Door Zone Relay Output35
EDPF - Electronic Door Protection (Front Doors) Input35
EDPR - Electronic Door Protection (Rear Doors) Input36
EP - Emergency Power Input36
EQK - Earthquake Detection Input36
HCB - Hall Call Bypass Input36
HFA - Hall Fire Alternate Input36
HFL - Hall Fire Light Output36
HFM Hall Fire Machine Room/Hoist Way Input36
HFR - Hall Fire Reset Input36
HFS - Hall Fire Service Input37
HFV - Hall Fire Visual Signal Output37
HV2 - High Voltage Input37
IDN - Inspection down Input37
IND - Independent Service Input37
INSP - Inspection Control Input37
IUP - Inspection up Input37
LEV - Leveling Relay Output38
LR - Lock Relay Input38
LR - Lock Relay Output38
LRX - Aux LR Input38
M3 - Door Locks Input38
MSD - Magnetic Switch down Input38
MSU - Magnetic Switch up Input38
NDGF - Nudging Buzzer Output Front Doors39
NDGR - Nudging Buzzer Output Rear Doors39
- NRF - Nudging Output Front Doors39
- NRR - Nudging Output Rear Doors39
- OS - out of Service Output39
- PI - Position Indicator Output39
- PRK - Parking Function Input40
- PRV - Proving Circuit Input40
- PULSE - Pulse Counting Input40
- SAF - Safety Circuit Input40
- Sin1 - BKSW - Brake Switch Input41
- Sin3 - HR Input41
- SO1 - Inspection Relay Output/Correction Run Output41
- SO2 - HR Output41
- SP1 - Multi Purpose Output 141
- SP2 - Multi Purpose Output 241
- SP3 - Multi Purpose Output 342
- SP4 - Multi Purpose Output 442
- TSL - Top Slowing Input42
- UD - Up/Dn Relay Output42
- UF - up Fast Relay Output42
- UHC - up Hall Call Inputs / Outputs42
- UP - up Relay Output42
- US - up Slow Relay Output43
Section 5. Liquid Crystal Display44
LCD Status Line44
- LCD Position & Direction44
- LCD Modes44
- LCD Lift Status45
- LCD Door Modes45
- LCD Control Buttons46
- LCD Display Options46
Section 6. Motion48
- Motion Control Outputs48
- Drive Settings and Their Output Status48
- Counting Method "00" - Magnet Counting56
- Counting Method "01" - Pulse Counting58
- Counting Method "02" - Pulse Counting67
Section 7: Faults - Fault Finding69
- Upgrade Controller Software69
- Group/Duplex Faults69
- Leveling Inhibit. LEV69
- Run Protection Timer. RPT69
- Lift Won't Re-Level with Doors Open69
- On Board Fuse Blows70
- Testing 24Vdc70
- Doors Do Not Open70
- Doors Close on Park70
- Doors Don't Open at Terminal Floors70
- Lift Gets out of Step70
- Lift Does Not Answer Car Calls70
- Lift Does Not Answer Hall Calls70
- Lift Misses Hall Calls70
- Re-Leveling Won't Operate71
- Red3 LED Is Not Blinking71
- Processor Errors/Lockup71
Section 8. Upgrades, Changes & Technical Information72
Controller ID73
Terminal Screw Torque Settings74

ECD 100-181 - Page 47

Table of Contents

Related product manuals