ECD 100-181 - Upgrades, Changes, and Technical Information; Upgrades, Changes, and Modifications

75 pages

Save Page as PDF

To Next Page

To Previous Page

Section 8. Upgrades, Changes & Technical Information

Upgrades, changes and modifications

When contacting us please have the board’s part number (printed in white on PCB), software version and software

build date (see Section 5).

Section

Main Page

Table of Contents3
Section 1: Safety Regulations & Introduction6
- Following Operating Instructions6
- Obligations of Operator6
- Obligations of Personnel6
- Hazards Associated with the Equipment7
- Warranty and Liability7
- 1.2.6 Organizational Measures7
- 1.2.7 Protective Equipment8
- 1.2.8 Informal Safety Measures8
- 1.2.9 Training of Personnel8
- 1.2.10 Machine Controls8
- 1.2.11 Safety Measures During Normal Operation8
- 1.2.12 Hazards Caused by Electric Power8
- 1.2.13 Hazards Caused by Hydraulic Power9
- Special Danger Areas (Examples)9
- 1.2.15 Controller Installation Environmental Requirements9
- Introduction10
Section 2: Eeprom Settings11
Eeprom Version 4.02 Summary12
Eeprom Definitions (Full Description)15
- ADO - Advanced Door Opening Setup15
- ALP - Auxiliary Leveling Pump Operation Setup15
- ANS - Anti Nuisance Setup15
- BCC - Bottom Car Call Setup15
- BOT - Bottom Floor Setup15
- BST - Brake Switch Time16
- CCMF - Car Call Mask (Front Doors) Setup16
- CCMR - Car Call Mask (Rear Doors) Setup16
- CNT - CNT Input Setup16
- COD - Parameter Lockout Function17
- DCMF - down Call Mask (Front Doors) Setup17
- DCMR - down Call Mask (Rear Doors) Setup17
- DLI - Door Limit Invert Setup17
- DLM - Door Limit Setup18
- DRV - Drive Type Setup18
- DT - Door Time Close Setup18
- DTCF - Door Time Car Call (Front Doors) Close Setup18
- DTCR - Door Time Car Call (Rear Doors) Close Setup18
- DTHF - Door Time Hall Call (Front Doors) Close Setup19
- DTHR - Door Time Hall Call (Rear Doors) Close Setup19
- DTL - Door Time Lobby Call Close Setup19
- DTRF - Door Time Recall Front Setup19
- DTRR - Door Time Recall Rear Setup19
- Eqk20
- FS - Fire Service Type20
- HFAF - Hall Fire Alternate (Front Doors) Floor Setup20
- HFAR - Hall Fire Alternate (Rear Doors) Floor Setup20
- HFSF - Hall Fire Service (Front Doors) Return Floor Setup20
- HFSR - Hall Fire Service (Rear Doors) Return Floor Setup21
- HRF - Hospital / Hall Recall Front Doors21
- HRR - Hospital / Hall Recall Rear Doors21
- LCK - Parameter Lockout Function21
- LOB - Lobby Floor Setup21
- L.# - Lift Number Setup21
- MOD - MODE Inputs Setup22
- MSL - Magnet Slowing Type22
- NR - Door Nudging Setup22
- PRK - Park/Zone with Doors Open22
- PRV - Proving Required Setup22
- RLV - Re-Leveling Setup22
- RPT - Run Protection Timer Setup23
- RTM - Run Time Short Floor Run Setup23
- SDX - Star Delta Exchange Time Setup23
- SDX - VF Drive Setting 06,07,08 Brake Drop Time23
- SFR - Short Floor Run Setup23
- Spares24
- Stf - Start Fast24
- Stm - Start Medium24
- Slf - Slow Fast24
- Slm - Slow Medium24
- ST2 - Star Delta Changeover Time Setup24
- ST2 - VF Drive Setting 06,07,08 End Run Time24
- TCC - Top Car Call Setup24
- TOP - Top Floor Setup25
- UCMF - up Call Mask (Front Doors) Setup25
- UCMR - up Call Mask (Rear Doors) Setup25
- XTM - Extend Run Time Short Floor Run25
- ZON - Zoning/Parking Floor Setup25
- ZTM - Zoning Time Setup26
- L - Number of Lifts Setup26
Section 3. Group27
- Group Connections and Communication27
- Group Checks28
- Group/Duplex Faults28
Section 4. Inputs - Outputs29
- BRK - Brake Relay Output29
- BSL - Bottom Slowing Input29
- CBSF - Hall Button Stop (Front Doors) Output29
- CBSR - Hall Button Stop (Rear Doors) Output29
- CC - Car Call Inputs/Darlington Outputs29
- CFS - Car Fire Service Input30
CFSS - Car Fire Service Start Input30
DCBF - Door Close Button (Front Doors) Input30
DCBR - Door Close Button (Rear Doors) Input30
DCF - Door Close (Front Doors) Relay Output30
DCR - Door Close (Rear Doors) Relay Output30
DDN - Direction down Output30
DDO - Door Open Disable Input / Toggle Switch30
DF - down Fast Relay Output31
DFCF - Door Fully Closed (Front Doors) Input31
DFCR - Door Fully Closed (Rear Doors) Input31
DFOF - Door Fully Open (Front Doors) Input33
DFOR - Door Fully Open (Rear Doors) Input33
DHC - down Hall Call Inputs/Darlington Outputs34
DN - down Relay Output35
DOBF - Door Open Button (Front Doors) Input35
DOBR - Door Open Button (Rear Doors) Input35
DOF - Door Open (Front Doors) Relay Output35
DOR - Door Open (Rear Doors) Relay Output35
DS - down Slow Relay Output35
DUP - Direction up Output35
DZ - Door Zone Input35
DZ - Door Zone Relay Output35
EDPF - Electronic Door Protection (Front Doors) Input35
EDPR - Electronic Door Protection (Rear Doors) Input36
EP - Emergency Power Input36
EQK - Earthquake Detection Input36
HCB - Hall Call Bypass Input36
HFA - Hall Fire Alternate Input36
HFL - Hall Fire Light Output36
HFM Hall Fire Machine Room/Hoist Way Input36
HFR - Hall Fire Reset Input36
HFS - Hall Fire Service Input37
HFV - Hall Fire Visual Signal Output37
HV2 - High Voltage Input37
IDN - Inspection down Input37
IND - Independent Service Input37
INSP - Inspection Control Input37
IUP - Inspection up Input37
LEV - Leveling Relay Output38
LR - Lock Relay Input38
LR - Lock Relay Output38
LRX - Aux LR Input38
M3 - Door Locks Input38
MSD - Magnetic Switch down Input38
MSU - Magnetic Switch up Input38
NDGF - Nudging Buzzer Output Front Doors39
NDGR - Nudging Buzzer Output Rear Doors39
- NRF - Nudging Output Front Doors39
- NRR - Nudging Output Rear Doors39
- OS - out of Service Output39
- PI - Position Indicator Output39
- PRK - Parking Function Input40
- PRV - Proving Circuit Input40
- PULSE - Pulse Counting Input40
- SAF - Safety Circuit Input40
- Sin1 - BKSW - Brake Switch Input41
- Sin3 - HR Input41
- SO1 - Inspection Relay Output/Correction Run Output41
- SO2 - HR Output41
- SP1 - Multi Purpose Output 141
- SP2 - Multi Purpose Output 241
- SP3 - Multi Purpose Output 342
- SP4 - Multi Purpose Output 442
- TSL - Top Slowing Input42
- UD - Up/Dn Relay Output42
- UF - up Fast Relay Output42
- UHC - up Hall Call Inputs / Outputs42
- UP - up Relay Output42
- US - up Slow Relay Output43
Section 5. Liquid Crystal Display44
LCD Status Line44
- LCD Position & Direction44
- LCD Modes44
- LCD Lift Status45
- LCD Door Modes45
- LCD Control Buttons46
- LCD Display Options46
Section 6. Motion48
- Motion Control Outputs48
- Drive Settings and Their Output Status48
- Counting Method "00" - Magnet Counting56
- Counting Method "01" - Pulse Counting58
- Counting Method "02" - Pulse Counting67
Section 7: Faults - Fault Finding69
- Upgrade Controller Software69
- Group/Duplex Faults69
- Leveling Inhibit. LEV69
- Run Protection Timer. RPT69
- Lift Won't Re-Level with Doors Open69
- On Board Fuse Blows70
- Testing 24Vdc70
- Doors Do Not Open70
- Doors Close on Park70
- Doors Don't Open at Terminal Floors70
- Lift Gets out of Step70
- Lift Does Not Answer Car Calls70
- Lift Does Not Answer Hall Calls70
- Lift Misses Hall Calls70
- Re-Leveling Won't Operate71
- Red3 LED Is Not Blinking71
- Processor Errors/Lockup71
Section 8. Upgrades, Changes & Technical Information72
Controller ID73
Terminal Screw Torque Settings74

ECD 100-181 - Upgrades, Changes, and Technical Information; Upgrades, Changes, and Modifications

Table of Contents

Related product manuals