11
4.3 Overload indicator light (red)
The overload indicator light (1) comes on when an overload of a connected
electrical device is detected, the inverter control unit overheats, or the
AC output voltage rises. Then, the AC protector will trip, stopping power
generation in order to protect the generator and any connected electric
(Red) will stay on, but the engine will not stop running.
When the overload indicator light comes on and power generation stops,
proceed as follows:
1.
2. Reduce the total wattage of connected electric devices within the rated
output.
3. Check for blockages in the cooling air inlet and around the control unit. If
any blockages are found, remove.
4. After checking, restart the engine.
TIP:
when using electric devices that require a large starting current, such as a
compressor or a submergible pump. However, this is not a malfunction.
4.4 AC pilot light (green)
The AC pilot light (1) comes on when the engine starts and produces power.
CONTROL FUNCTION
To Next Page
Loading...
Need help?
General
