18
4. Lay the pruner on a at clear area. Firmly grasp right hand grip
and throttle trigger lockout with left hand and fully depress throttle
trigger to wide open position. Rapidly pull recoil starter handle
until engine res (or maximum ve [5] pulls).
5. After engine res or ve (5) pulls, move choke lever to “Run”
position. Hold throttle trigger and throttle lockout fully depressed
and pull recoil starter handle until engine starts and runs. Release
throttle trigger and allow unit to warm up at idle for several min-
utes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls,
repeat instructions.
6. After engine warm up, gradually depress throttle trigger to increase
engine to operating speed.
startIng warm engIne
The starting procedure is the same as Cold Start except DO NOT close
the choke, and do not depress throttle trigger to wide open position.
WARNING
The cutting attachment should not move at idle. If cutting at-
tachment moves, readjust carburettor according to "Carburettor
Adjustment" instructions in this manual or ask your ECHO Dealer,
otherwise serious personal injury may result.
1. Stop Switch - Start/Run.
Move Stop Switch forward away from the STOP position.
2. Purge Bulb .
Pump purge bulb until fuel is visible and ows freely in the
“Clear” fuel return line. Pump purge bulb an addition 4 or 5 times
3. Start - Pull Rope.
Lay the pruner on a at clear area and pull the recoil starter handle
until the engine res.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
stoppIng engIne
1. Release Throttle.
Allow engine to return to idle before shutting engine off.
2. Stop Switch - Stop.
Move stop switch backward to STOP position.
WARNING
If engine does not stop when stop switch is moved to STOP posi-
tion, close choke - COLD START position - to stall engine. Have
your ECHO dealer repair stop switch before using pruner again.
Starter handle
Stop switch
Stop switch
Start/Run
Primer bulb
Choke lever
Starter handle
To Next Page
Loading...
Need help?
General