Power Pruner™
oPerator's Manual
19
BLADE HITS REAR BRANCH
NOT CORRECT
CORRECT
GUIDE AGAINST BRANCH
prunIng technIques
The Power Pruner
TM
is designed for light to medium trimming of limbs
and branches up to 20 cm in diameter. Follow these tips for successful
operation.
• Plan cut carefully. Check direction branch will fall.
• Plan retreat path from falling branch. Cut branches bounce when
striking ground.
• Long branches should be removed in several pieces.
• Do not stand directly beneath branch being cut.
• When ready to cut:
Hold "cutting shoe" against branch. This will prevent whipping of the
branch. DO NOT use back and forth sawing action.
• Look out for branch immediately behind the branch being cut. If saw
chain hits rear branch damage to saw chain and guide bar may occur.
• Accelerate to full throttle.
• Apply cutting pressure.
• Ease cutting pressure when nearing end of cut to maintain control.
• When pruning a limb 10 cm diameter or larger cut as follows:
1. Under cut 1/4 limb diameter near tree trunk.
2. Finish top cut slightly farther out on limb.
3. Flush cut stub at trunk.
• DO NOT use for felling or bucking.
not correct
Cutting shoe