Power Pruner™
oPerator's Manual
21
fuel fIlter
Level 1.
Tools Required: 20 to 25 cm length of wire with one end bent into a
hook. Clean rag, funnel, and an approved fuel con-
tainer
Parts Required: Fuel Filter
DANGER
Fuel is VERY ammable. Use extreme care when mixing, storing
or handling or serious personal injury may result.
1. Use a clean rag to remove loose dirt from around fuel cap and empty
fuel tank.
2. Use the “fuel line hook” to pull the fuel line and lter from the tank.
3. Remove the lter from the line and install the new lter.
aIr fIlter
Level 1.
Tools Required: 25 or 50 mm medium bristle cleaning brush
Parts Required: Air Filter
1. Close choke (Cold Start Position). This prevents dirt from entering
the carburettor throat when the air lter is removed. Brush accumu-
lated dirt from the air cleaner area.
2. Remove the air cleaner cover. Clean and inspect the element for dam-
age. If element is fuel soaked and very dirty, replace.
3. If element can be cleaned and reused, be certain it:
• properly ts the cavity in the air cleaner cover.
• is installed with the original side out.
NOTE
Carburettor adjustment may be needed after air lter cleaning/re-
placement. See Carburettor Adjustment Section.
To Next Page
Loading...
Need help?
General