Ecolab Aquanomic - Page 32

32
System Menu #3.0
1. Washer Settings
2. Detergent
3. Bleach
4. Finish
5. Optional Form Select
6. Optional Solid Product4
7. Optional Liquid Product
8. Select Textile Type
9.Reset Setup Menu
10. Reset All
6. OPTIONAL SOLID PRODUCT4
Setup Menu >Optional Solid Product4 #3.6
1. No
2. YES
1.NO
When select to enable the forth product:
Setup Menu>Optional Solid Product4 #3.6.1
Current Product: LT Sour 4th
1. Change Product4
2. Change Product Factor
Setup Menu >Optional Solid Product4 #3.6
1. No
2. Yes
2. YES
Setup Menu>Optional Solid Product4 #3.6.1
Current Product: LT Sour 4th
1. Change Product4
2. Change Product Factor
1. CHANGE PRODUCT4
Setup Menu>Change Product #3.6.1.1
1. Break Plus
2. LT Break
3. LT Sour 4th
4. LT IC Sour 4th
4. LT SOUR 4TH
2. CHANGE PRODUCT FACTOR
...Menu>Product4>Change Product Factor #3.6.1.2
7 5 8 7 9 0 6 5 1 8 4 7 3 8 3 0 8 1
(Use Left/Right/Up/Down to change)
7
Press SK#3 <Save> to save selection.
Press <Back> to cancel selection.
2.3.7 Submenu #3.7 System Menu>Optional Liquid Product:
Enable the optional liquid product. Default setup is No.
Use Up/Down arrow keys to highlight a selection.
Press SK#3 <Save> to save selection.
Press <Back> to cancel selection.
System Menu #3.0
1. Washer Settings
2. Detergent
3. Bleach
4. Finish
5. Optional Form Select
6. Optional Solid Product4
7. Optional Liquid Product
8. Select Textile Type
9.Reset Setup Menu
10. Reset All
7. OPTIONAL LIQUID PRODUCT
Setup Menu >Optional Liquid Product #3.7
1. No
2. Yes
1. NO
When select to enable the liquid product:
Setup Menu >Optional Liquid Product #3.7
1. No
2. Yes
2. YES
...Menu>Optional Liquid Product>Liquid Product #3.7.2
1. Advacare 120
2. Water Treatment MC
3. Sour 7
4. Turbo Boost
3.SOUR 7
you can also map the washers to the liquid pumps by pressing on SK#2 <Signal Mode>. Choosing SK#3 <Reset> will
unmap the liquid pumps, and choosing SK#2 <Edit Product> will allow remapping the pumps to the desired washers: