15
5. Transportation & installation
5.1. Transportation
•
tipping during transport.
• Transport the unit only in a horizontal position.
• Do not place the unit on the front where the
where connections and outlets are located.
•
5.2. Installation preparations
• -
sons before installing the equipment.
• Follow the applicable laws and regulations at the
• Installation must always be in accordence with
local legistration.
•
the unit for easier maintenance.
• Ensure sufficient wall space for additional I/O
installation manual).
•
the unit.
5.3. Mounting Instructions
• Only install the unit in a frost-free area.
•
the wall.
•
frame anchored to the floor.
• -
•
wall using the enclosed screws and rawplugs.
• -
sure it can support the weight of the unit.
•
two screws through designated holes.
• Secure the unit in the top by two screws through
-
ings in section 13.1 and 13.3.
•
any.
5.4. Electrical installation
-
grams and ratings.
5.4.1. Power supply
Connection instruction is mounted on the cables.
The phase order is subordinated.
5.4.2. Earth leakage circuit breaker (ELCB).
•
•
• Note that the 30mA used in households can malfunction
5.4.3. Service switch
The unit must always be connected to the main sup-
MAxxx SAxxx
Voltage:
Frequenz:
Motor load: -
Total load
Nominal current: 1 A
Fuse: 20 A
2.5 mm
2
1.5 mm
2
5.5. I/O Modules
For instructions on installation of additional I/O
manual.
5.6. Water connection
section 3.5.
•
To Next Page
Loading...
