8.7 Sensors ID
(1) Supports viewing and registering sensor ID.
(2) Viewing battery status and signal quality.
(3) By entering the
“
Edit
”
sub-page of a particular sensor, you may
register the sensor by entering the sensor ID so that this sensor can be
mandatorily assigned. You can also choose to disable the sensor.
It is good practice to disable all sensor ID slots of sensors which you don
’
t
have or don
’
t use with your console/gateway in order to avoid the
reception of
“
ghost
”
sensors from other weather stations in your
neighbourhood.
(4) By entering the “Re-register,” the gateway will learn the sensor again
to ensure its presence. If a new sensor is discovered, it will be displayed
here with its sensor ID updated.
To Next Page
Loading...
