6. Sensor start up
1. Ensure the gateway is in sensor learning mode.
Hold the Reset button for 3 seconds will turn on the receiver and will be
in sensor learning mode. The RF LED will flash two times per second for
3 minutes until the learning process is completed.
2. Power up the sensor.
Power up your sensor array, and the Web-UI dashboard should be able to
show up the sensor data on the dashboard immediately after registration .
If all data looks normal, you can temporarily store the gateway and sensor
to ensure the system works. Then, refer to section 7 and complete the
installation in its permanent location.
For sensor mounting, you may refer to the specific sensor instruction
manual.
To Next Page
Loading...
