To Next Page

To Previous Page

Installing the Motherboard

Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is

labeled.

Jumper Settings

To avoid the system instability after clearing CMOS, we recommend

users to enter the main BIOS setting page to “Load Optimized Defaults”

and then “Save & Exit Setup”.

Make sure the power supply provides enough VCC5_DUAL voltage

before selecting the VCC5_DUAL function.

It is required that users place the USBPWR_F & USBPWR_R cap onto

2-3 pin rather than 1-2 pin as default if you want to wake up the

computer by USB/PS2 KB/Mouse.

Jumper Type Description Setting (default)

CLR_CMOS

3-pin

CLEAR CMOS

1-2: NORMAL

2-3: CLEAR

Before clearing the

CMOS, make sure to

turn the system off.

3-pin

USBPWR_R

1-2: VCC5

2-3: VCC5_DUAL

Rear USB/PS2

Power Select

Jumper

3-pin

USBPWR_F

1-2: VCC5

2-3: VCC5_DUAL

Front Panel

USB Power

Select Jumper

USBPWR_F

CLR_CMOS

USBPWR_R

Questions and Answers:

Need help?

Do you have a question about the ECS MCP61M-M3 and is the answer not in the manual?

ECS MCP61M-M3 Specifications

General

Number of memory slots	2
Maximum internal memory	8 GB
Processor socket	Socket AM3
Processor manufacturer	AMD
USB 2.0 connectors	3
Power fan connector	Yes
Number of SATA connectors	4
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN (RJ-45) ports	1
Audio chip	VIA VT1705
Power source type	ATX
Audio output channels	6.1 channels
Motherboard form factor	micro ATX
BIOS memory size	64 Mbit