ECS Motherboard

41
Using BIOS
HDD Off After (Disabled)
The IDE hard drive will spin down if it is not accessed within a specified length of time.
Options are from 1 Min to 15 Min and Disable.
Power Button Override (Instant Off)
Under ACPI (Advanced Configuration and Power management Interface) you can create a
software power down. In a software power down, the system can be resumed by Wake Up
Alarms. This item lets you install a software power down that is controlled by the power
button on your system. If the item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec. then you have to hold the power
button down for four seconds to cause a software power down.
Power On After Power Fail (Always Off)
This item enables your computer to automatically restart to its last operating status after
power returns from a power failure.
This item opens a submenu that enables you to set events that will resume the system from
a power saving mode.
IRQ [3-7, 9-15], NMI (Enabled)
This option determines whether any activity for IRQ 3-7/9-15 will cause the system to
wake from a power saving mode.
fPM Wake Up Events
Scroll to this item and press <Enter> to view the following screen:
Phoenix-AwardBIOS CMOS Setup Utility
PM Wake Up Events
Item Help
ff
Menu Level
IRQ [3-7, 9-15], NMI [Enabled]
IRQ 8 Break Suspend [Disabled]
Resume By RING [Disabled]
Resume By MACPME [Enabled]
Resume By PCIPME [Enabled]
Power Up by Alarm [Disabled]
Month Alarm NA
Day of Month Alarm 0
Time (hh:mm:ss) Alarm 0 : 0 : 0
** Reload Global Timer Events **
Primary IDE [Disabled]
Secondary IDE [Disabled]
FDD, COM, LPT Port [Disabled]
PCI PIRQ [A-D] [Disabled]
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
mnlk
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
• IRQ 8 Break Suspend (Disabled): Determines whether the system will
monitor IRQ 8 activity and wake the system from a power saving mode when
IRQ 8 is activated.
• Resume by RING (Disabled): An input signal on the serial Ring Indicator (RI)
line (in other words, an incoming call on the modem) awakens the system
from a soft off state.
x
x
x