ECS Motherboard

42
Using BIOS
• Resmue by MACPME (Enabled): Use this item to enable MAC activity to
wakeup the system from a power saving mode.
Resume by PCI PME (Enabled)
This item specifies whether the system will be awakened from power saving modes when
activity or input signal of the specified hardware peripheral or component is detected.
** Reload Global Timer Events **
These fields determine which events waken the system from power saving mode.
Power Up by Alarm (Disabled)
When set to Enabled, the following three fields become available: Month Alarm, Day of
Month Alarm, and Time Alarm Upon arrival of the alarm time, it will instruct the system
to wake up.
When set to 0 (zero) for the day of the month, the alarm will power on your system every
day at the specified time.
Primary/Secondary IDE (Disabled)
When this item is enabled, the system power will resume the system from a power saving
mode if there is any activity on primary or secondary IDE channels 0 or 1.
FDD, COM, LPT Port (Disabled)
When this item is enabled, the system will restart the power-saving timeout counters when
any activity is detected on the floppy disk drive, serial ports, or the parallel port.
PCI PIRQ[A-D] (Disabled)
When this item is enabled, any activity from one of the listed devices wakes up the system.
Delay Prior to Thermal ( None)
Enables you to set the delay time before the CPU enters auto thermal mode.
Press <Esc> to return to the Power Management Setup screen.