EDAN FTS-3 - 10.5 Disassembling the Lower assembly

FTS-3 Fetal Telemetry System Service Manual Disassembling FTS-3
- 34 -
10.4.2 Replacing the Indicative Light Board
To remove the indicative light board,
(1) Separate the upper assembly and the lower assembly.
(2) Turn on the connector swich with both index fingertips and remove the adhesive tape.
Refer to Figure 10-9.
(3) Disconnect the wire.
(4) Remove four screws securing the charging interface board.
To install the charging interface board,
Install the indicative light board, in a reverse procedure. Refer to the following illustration when
connecting the wires. Ensure it is correctly connected.
Figure 10- 11
No.
Connect to
1
Main Borad
2
Charging Interface Board
3
Batery Module
10.5 Disassembling the Lower assembly
10.5.1 Replacing the Power Module
To remove the power module,
(1) Separate the upper assembly and the lower assembly.
(2) Remove the transparent cover over the power module.
1 2 3
理邦保密文件
EDAN CONFIDENTIAL