EDAN FTS-3 - Replacing the Main Board

FTS-3 Fetal Telemetry System Service Manual Disassembling FTS-3
- 36 -
No.
Connect to
1
AC Power Interface
2
Power Switch
3
Indicative Light Board
4
Base Station Battery Interface
10.5.2 Replacing the Main Board
To remove the main board,
(1) Separate the upper assembly and the lower assembly.
(2) Remove the adhesive paper and all the connecting lines.
Figure 10- 14
(5) Remove five screws securing the power module.
To install the main board,
Install the main board, in a reverse procedure. Refer to the following illustration when connecting
the wires. Ensure they are correctly connected.
理邦保密文件
EDAN CONFIDENTIAL