EDAN iM3 - C Default Settings; Patient Information Default Settings; Alarm Default Settings; Spo Default Settings

Vital Signs Monitor User Manual Default Settings
- 151 -
C Default Settings
This appendix documents the most important default settings of your monitor as it is delivered
from the factory.
Note: If your monitor has been preconfigured according to your requirements, the settings at
delivery will be different from the default settings listed here.
C.1 Patient Information Default Settings
Patient Information Settings
Patient Type Adult
C.2 Alarm Default Settings
Alarm Settings
Pause Time 120 s
Alarm Latch Off
C.3 SpO
2
Default Settings
SpO
2
Settings ADU PED NEO
Alarm Switch On
Alarm Record Off
Alarm Level Medium
Alarm High Limit 100 100 95
Alarm Low Limit 90 90 88
NIBP/SpO
2
Simul
Measurement
Off
Pitch Tone On
Sensitivity Medium
SatSeconds (Nellcor
Module)
Off
Sweep 12.5 mm/s
Alert Switch On
Alert High Limit 100 100 95
Alert Low Limit 90 90 88
SpO
2
Desat Limit 80%