Vital Signs Monitor User Manual User Interface
- 68 -
Chapter 10 User Interface
Changing some settings may have the risk, so only the authorized person can change them. After
changing the settings, please notify the operator.
10.1 Setting Interface Style
The user can set the interface based on the requirement, such as: Parameters needing to be
monitored.
10.2 Selecting Display Parameters
The user can select the display parameters based on the monitoring and measurement
requirements.
Click Menu > Parameters Setup to select the required parameters from the popup interface >
Confirm.
Exit the menu and the screen will adjust the parameters automatically.
10.3 Changing Parameter and Waveform Colors
The user can set the display colors of parameter and waveform as desire. Click respective
parameter area to enter parameter setup menu > Color Setup to make color changes on parameter
and waveform.
NOTE:
The colors won’t be affected by the default factory Settings.
10.4 User Configuration
Users can save the current monitor’s configuration, delete the saved user configuration and
rename it. Three pieces of user configuration can be saved in the monitor. User can select as
desire. The one labeled with ● is current configuration.
To save the user configuration:
1. Select Menu > Default Setup > User Configure.
2. Click on Save, enter a file name for the configuration and confirm it. A message will display
after the operation.
To delete the user configuration:
1. Select Menu > Default Setup > User Configure.
2. Select the configuration file needed to delete from the list, click on Delete and confirm the
operation. A message will display after the operation.
To Next Page
Loading...
